User manual

APS User Manual
63
1.2.2-2 Rate Limiters
The section describes how to configure the ACL Rate Limiting Parameters. Up to 16 different rate
limits can be set and applied to individual ports. Rate Limits can be set in either pps (Packets Per
Second) or Kbps (Kilo Bits Per Second). Only 1 rate limit can be applied to each port.
Web Interface
To configure the ACL Rate Limiters via the Web Interface:
1. Click Configuration, ACL and Rate Limiters.
2. Configure up to 16 Rate Limiters, using either pps or Kbps.
3. Click the Apply button to save your changes or the Reset button to revert to previous
settings.
Parameter Description
Rate Limiter ID: The Rate Limiter ID, from 1 through to 16.
Rate: Enter the required rate that you want to limit traffic flow to. If you are using
Kbps, rates must be set in increments of 100.
Fig. 28 Rate Limiter Configuration