User manual

APS User Manual
33
1.1.6-3 Communities
This section is used to configure additional communities. These communities can be used to secure
the SNMP information by allowing only certain users and IP Addresses to be able to access a specific
community. The maximum number of communities that can be created is four.
Web Interface
To configure communities via the Web Interface:
1. Click System, SNMP and Communities.
2. Click add new community.
3. Enter a valid community name, a username, Source IP Address and subnet mask.
4. Click Save to apply your changes.
Parameter Description
Delete: Select the tick box and click the apply button to delete a community name.
Add New Community: Used to add a new community.
Fig. 16 SNMP Additional Community Configuration