User manual

APS User Manual
328
1.4.5-2 Ping6
This section is used to test network connectivity issues using the Ping IPv6 command.
Web Interface
To test IPv6 network connectivity using the switch via the Web Interface:
1. Click Maintenance, Diagnostics and Ping.
2. Enter the IP Address of the device you are trying to communicate with.
3. Set the ping Data Length, Ping Count and Ping Interval.
4. Click the Start button to commence the test.
Parameter Description
IP Address: The destination IP Address you want to ping it.
Ping Length: The payload size of the ICMP packet. Values range from 2 bytes to 1452
bytes.
Ping Count: The count of the ICMP packet. Values range from 1 time to 60 times.
Ping Interval: The interval of the ICMP packet. Values range from 0 second to 30 seconds.
Fig. 158 Ping IPv6 Command