User manual

APS User Manual

1.1.6 SNMP

The APS Series Switches support SNMP and can be managed by any Network Management System

(NMS). SNMP is a protocol that is used to govern the transfer of information between SNMP

manager and agent and traverses the Object Identity (OID) of the management Information Base

(MIB), described in the form of SMI syntax. A SNMP agent is running on the switch and if enabled will

respond to the requests issued by a SNMP manager.

1.1.6-1 System

This section is used to enable or disable the SNMP Agent in the switch.

Web Interface

To enable or disable SNMP via the Web Interface:

1. Click System, SNMP and System.

2. Select to enable or disable the SNMP function by selecting the relevant radio button.

3. Enter a valid engine ID. This is used for SNMPv3 and should not need to be changed.

4. Click the Apply button to save your changes.

Parameter Description

SNMP State: Used to enable or disable the SNMP Agent in the switch.

Engine ID: SNMPv3 Engine ID. Syntax: 0 – 9, a – f, A – F. Minimum 5 Octet, Maximum

32 Octet.

Fig. 14 SNMP Settings