User manual

APS User Manual
306
1.3.8 Access Management
The APS Series switches supports a number of methods for configuring the switch. This section is
used to allow/deny specific IP Addresses from accessing HTTP/HTTPS, SNMP or Telnet/SSH access.
1.3.8-1 Configuration
This section is used to configure the Access Management function of the APS Series switch.
Web Interface
To configure the Access Management settings via the web interface:
1. Click Security, Access Management and Configuration.
2. Click Add New Entry.
3. Specify the start and end IP Address and select the type of access allowed.
4. Click the Apply button to save your changes or the Reset button to revert to previous
settings.
Parameter Description
Mode: Indicates the access management mode operation. Possible modes are:
Enabled: Enable access management mode operation.
Disabled: Disable access management mode operation.
Fig. 143 Access Management Configuration