User manual

APS User Manual
299
1.3.7 Port Security
The APS Series switches supports a Port Security function allowing the administrator to specify the
amount MAC Addresses allowed to be accessed by an individual port.
1.3.7-1 Limit Control
This section is used to configure the amount of MAC Addresses allowed to by the port and you can
also specify the action taken once this configured threshold has been reached
Web Interface
To configure the Port Security limitations via the web interface:
1. Click Security, Port Security and Limit Control.
2. Specify the appropriate system settings for your configuration.
3. Enable per port settings based on your requirements.
4. Click the Apply button to save your changes or the Reset button to revert to previous
settings.
Parameter Description
Mode: Indicates if Limit Control is globally enabled or disabled on the switch. If
globally disabled, other modules may still use the underlying functionality,
but limit checks and corresponding actions are disabled.
Fig. 140 Port Security Limit Control