User manual

APS User Manual
295
This variable is incremented when an
Access-Request is sent and decremented
due to receipt of an Access-Accept, Access-
Reject, Access-Challenge, timeout, or
retransmission.
Tx
Timeouts
radiusAuthClientExtTimeou
ts
The number of authentication timeouts to
the server. After a timeout, the client may
retry to the same server, send to a
different server, or give up. A retry to the
same server is counted as a retransmit as
well as a timeout. A send to a different
server is counted as a Request as well as a
timeout.
Other Info: This section contains information about the state of the server and the
latest round-trip time.
Name
RFC4668 Name
Description
IP Address
-
IP address and UDP port for the authentication server in
question.
State
-
Shows the state of the server. It takes one of the following
values:
Disabled: The selected server is disabled.
Not Ready: The server is enabled, but IP communication is
not yet up and running.
Ready: The server is enabled, IP communication is up and
running, and the RADIUS module is ready to accept access
attempts.
Dead (X seconds left): Access attempts were made to this
server, but it did not reply within the configured timeout.
The server has temporarily been disabled, but will get re-
enabled when the dead-time expires. The number of
seconds left before this occurs is displayed in parentheses.
This state is only reachable when more than one server is
enabled.
Round-
Trip Time
radiusAuthClientExtRoundT
ripTime
The time interval (measured in milliseconds) between the
most recent Access-Reply/Access-Challenge and the