User manual

APS User Manual
276
assigned VLAN is enabled on that port. When unchecked, RADIUS-server
assigned VLAN is disabled on all ports.
Guest VLAN Enabled: A Guest VLAN is a special VLAN - typically with limited network access - on
which 802.1X-unaware clients are placed after a network administrator-
defined timeout. The switch follows a set of rules for entering and leaving
the Guest VLAN as listed below.
The "Guest VLAN Enabled" checkbox provides a quick way to globally
enable/disable Guest VLAN functionality. When checked, the individual
ports' ditto setting determines whether the port can be moved into Guest
VLAN. When unchecked, the ability to move to the Guest VLAN is disabled
on all ports.
Guest VLAN ID: This is the value that a port's Port VLAN ID is set to if a port is moved into
the Guest VLAN. It is only changeable if the Guest VLAN option is globally
enabled.
Valid values are in the range [1; 4095].
Max. Reauth. Count: The number of times the switch transmits an EAPOL Request Identity frame
without response before considering entering the Guest VLAN is adjusted
with this setting. The value can only be changed if the Guest VLAN option is
globally enabled.
Valid values are in the range [1; 255].
Allow Guest VLAN if EAPOL Seen: The switch remembers if an EAPOL frame has been received on the
port for the life-time of the port. Once the switch considers whether to
enter the Guest VLAN, it will first check if this option is enabled or disabled.
If disabled (unchecked; default), the switch will only enter the Guest VLAN if
an EAPOL frame has not been received on the port for the life-time of the
port. If enabled (checked), the switch will consider entering the Guest VLAN
even if an EAPOL frame has been received on the port for the life-time of
the port.
The value can only be changed if the Guest VLAN option is globally enabled.
Port Configuration: The table has one row for each port on the selected switch and a number of
columns, which are:
Port: Physical port of the switch.
Admin State: If NAS is globally enabled, this selection controls the port's authentication
mode. The following modes are available:
Force Authorized: In this mode, the switch will send one EAPOL Success