User manual

APS User Manual
249
1.2.22 SMTP Configuration
The APS Series switches support trap events that can alert the administrator if a particular event
occurs. This section is used to configure the mail server settings that will be used to send the emails.
Email Addresses can also be configured here, these will be the addresses the events will be sent to.
Web Interface
To configure the SMTP Configuration settings via the Web Interface:
1. Click Configuration and SMTP Configuration.
2. Enter the appropriate parameters as required.
3. Click the Apply button to save your changes or the Reset button to revert to previous
settings.
Parameter Description
Mail Server: Specify the IP Address of the mail server used to send/relay the emails.
Username: Specify the username for the mail server. (If required)
Password: Specify the password for the mail server. (If required)
Sender: Enter an email address for which the emails will be sent from.
Return-Path: Set the mail Return-Path as sender mail address.
Fig. 122 SMTP Configuration