User manual

APS User Manual
243
sure the box is unchecked.
By default, no ports are members.
Role: The port role is based on the type of devices to be connected to the switch
ports. Scroll to select the type of device that will connect to the port.
Options are IP-Phone, IP-CAM and WIFI-AP.
Access VLAN: Used to set the Access VLAN ID. Allowed range is 1 to 4095.
VLAN Mode: Scroll to select the Port Egress Rule. The allowed values are Hybrid, Trunk or
Access. This parameter affects VLAN egress processing. If Trunk is selected, a
VLAN tag with the classified VLAN ID is inserted in frames transmitted on the
port. This mode is normally used for ports connected to VLAN aware device.
If Hybrid (the default value) is selected, if the classified VLAN ID of a frame
transmitted on the port is different from the Port VLAN ID, a VLAN tag with
the classified VLAN ID is inserted in the frame. If Access is selected, untag all
frames transmitted on the port.
Voice VLAN: Indicates the Voice VLAN ID. It should be a unique VLAN ID in the system
and cannot equal any other configured port PVID. A conflict will occur if the
VLAN ID is the same as the management VID, MVR VID, PVID etc. The
allowed range is 1 to 4095.
Traffic Class: Scroll to select the traffic class for the data stream priority. The available
values from 0 (Low) to 7 (High). If you want voice to have a high priority then
you can set the value to 7.
Port Security: Scroll to enable or disable the Port Security function on the Port. If you turn
on the function then you need to set Port Security limit to allow how many
device can access the port (via MAC address).
Port Security Action: If Limit is reached, the switch can take one of the following actions:
None: Do not allow more than Limit MAC addresses on the port, but take no
further action.
Trap: If Limit + 1 MAC addresses is seen on the port, send an SNMP trap. If
Aging is disabled, only one SNMP trap will be sent, but with Aging enabled,
new SNMP traps will be sent every time the limit gets exceeded.
Shutdown: If Limit + 1 MAC addresses is seen on the port, shut down the
port. This implies that all secured MAC addresses will be removed from the
port, and no new address will be learned.
Port Security limit: The maximum number of MAC addresses that can be secured. This number
cannot exceed 1024. If the limit is exceeded, the corresponding action is
taken. The switch is "born" with a total number of MAC addresses from
which all ports draw whenever a new MAC address is seen on a Port