User manual

APS User Manual
239
Parameter Description
Mode: Is used to disable the SIP function or set the device as a Master or Slave.
Possible modes are:
Disable: Disable operation of Single IP Management.
Master: Enable Single IP Management and run as a Master Switch. Running
as the master switch the user will connect to the Master switches IP Address
and can then control the Slave switches in the same SIP group.
Slave: Enable Single IP Management and run as a Slave Switch. The user will
connect to the management of this switch via the Master Switches IP
Address.
Group Name: The specific group name of the Single IP Management Group. All switches
that belong to this group will be controlled by the Master Switch of the
group.
Reset Button: Used to reset unsaved changes to original configuration.
Apply Button: Used to save the settings configured on this page.