User manual

APS User Manual
233
Reset Button: Used to reset unsaved changes to original configuration.
Apply Button: Used to save the settings configured on this page.
1.2.16-2 Sampler
This section is used to configure the s-Flow sampling rate that is sent to the receiver. An average of 1
out of N packets/operations is randomly sampled. This type of sampling does not provide a 100%
accurate result, but it does provide a result with quantifiable accuracy
Web Interface
To configure the s-Flow Agent Sampling settings via the Web Interface:
1. Click Configuration, s-Flow Agent and Sampler.
2. Click the button to edit the s-Flow sampling parameters.
3. Select whether the samples will taken from RX, TX or all packets.
4. Click the Apply button to save your changes or the Reset button to revert to previous
settings.
Fig. 113 s-Flow Agent Sampler Settings