User manual

APS User Manual
219
1.2.15-8 DSCP Translation
This section is used to configure DSCP translation for ingress traffic or DSCP re-mapping for egress
traffic.
Web Interface
To configure the DSCP Translation settings via the Web Interface:
1. Click Configuration, QoS and DSCP Translation.
2. Set the required ingress translation and egress re-mapping parameters.
3. Click the Apply button to save your changes or the Reset button to revert to previous
settings.
Parameter Description
DSCP: DSCP value. Range is 0 – 63.
Ingress Translate: Enables ingress translation of DSCP values based on the specified
classification method.
Ingress Classify: Enable Classification at ingress side as defined in the QoS Port DSCP
Configuration table.
Fig. 105 DSCP Translation