User manual

APS User Manual
215
1.2.15-6 Port DSCP
This section provides an overview of QoS Port DSCP settings for all switch ports.
Web Interface
To configure the QoS Port DSCP settings via the Web Interface:
1. Click Configuration, QoS and Port DSCP.
2. Check the tick box next to each corresponding port to enable the DSCP feature.
3. Specify the Ingress Classify parameter and whether the Egress packets will be rewritten.
4. Click the Apply button to save your changes or the Reset button to revert to previous
settings.
Parameter Description
Port: Physical port of the switch.
Ingress Translate: To enable ingress translation of the DSCP value enable this feature.
Classify: Classification values available for the port are as follows:
Disable: No Ingress DSCP Classification.
DSCP=0: Classify if incoming (or translated if enabled) DSCP is 0.
Selected: Classify only selected DSCP values for which classification is
Fig. 103 Port DSCP Settings