User manual

APS User Manual
207
Port Shaper Rate: Enter the required bandwidth rate, maximum values are based on the speed
on the port. If running at 1Gb, 1000000 Kbps or 1000Mbps.
Default value is 500.
Port Shaper Unit: Select whether the shaping rate is measured in kbps or Mbps.
Default is kbps.
Reset Button: Used to reset unsaved changes to original configuration.
Apply Button: Used to save the settings configured on this page.
QoS Egress Port Scheduler and Shapers (Weighted)
Scheduler Mode: Select the required Scheduler Mode for the port, Strict Priority or Weighted.
Queue Shaper Enable: Tick the box next to the appropriate queue to enable the Queue Shaper.
Queue Shaper Rate: Enter the required bandwidth rate, maximum values are based on the speed
on the port. If running at 1Gb, 1000000 Kbps or 1000Mbps.
Default value is 500.
Queue Shaper Unit: Select whether the shaping rate is measured in kbps or Mbps.
Default is kbps.
Queue Shaper Excess: Enable this if the queue is allowed to use excess bandwidth available on the
switch.
Queue Scheduler Weight: Controls the weight of the queue. This is a percentage of total bandwidth
available, valid values 1 to 100.
Default is 17.
Queue Scheduler Percent: Shows the weight in percent for this queue.
Port Shaper Enable: Tick the box to enable Port shaping on the selected port.
Port Shaper Rate: Enter the required bandwidth rate, maximum values are based on the speed
on the port. If running at 1Gb, 1000000 Kbps or 1000Mbps.
Default value is 500.
Port Shaper Unit: Select whether the shaping rate is measured in kbps or Mbps.
Default is kbps.
Reset Button: Used to reset unsaved changes to original configuration.
Apply Button: Used to save the settings configured on this page.