User manual

APS User Manual
204
Parameter Description
Port: Physical port of the switch.
Mode: Check the box next to the corresponding port to enable Ingress port
policing.
Rate: Set the Rate that you want to limit the ingress bandwidth to.
Default vale is 500.
Unit: Select the required speed type in units of kbps, Mbps, fps or kfps.
Flow Control: Check the box to enable Flow Control on the selected port.
Reset Button: Used to reset unsaved changes to original configuration.
Apply Button: Used to save the settings configured on this page.
1.2.15-3 Port Scheduler
This section provides an overview of QoS Egress Port Schedulers for all switch ports.
Web Interface
To configure the QoS Port Scheduler settings via the Web Interface:
1. Click Configuration, QoS and Port Scheduler.
2. Click on the required port to configure the scheduling options.
3. You will now be prompted with another screen, here you can select to use Strict Priority or
Weighted.
4. Configure your Egress bandwidth parameters based on Queue Settings or force the port to a
desired speed. If using Weighted a total percentage of a queue can also be set.
5. Click the Apply button to save your changes or the Reset button to revert to previous
settings.