User manual

APS User Manual
203
DSCP Based: Click to Enable DSCP Based QoS Ingress Port Classification.
Reset Button: Used to reset unsaved changes to original configuration.
Apply Button: Used to save the settings configured on this page.
1.2.15-2 Port Policing
This section provides an overview of QoS Ingress Port Policers for all switch ports The Port Policing is
useful in constraining traffic flows and marking frames above specific rates. Policing is primarily
useful for data flows and voice or video flows because voice and video usually maintains a steady
rate of traffic.
Web Interface
To configure the QoS Port Policing settings via the Web Interface:
1. Click Configuration, QoS and Port Policing.
2. Enable the ports that to wish to enable policing on.
3. Enter the required rates and the units in kbps, Mbps, fps or kfps.
4. Tick the check box to enable flow control on required ports.
5. Click the Apply button to save your changes or the Reset button to revert to previous
settings.
Fig. 92 QoS Port Policing