User manual
APS User Manual
180
1.2.11-5-2 Port Isolation
Port Isolation allows the administrator to configure ports so they can only communicate with certain
ports, even though they are in the same VLAN group. A typical scenario is where you need to block
all ports from communicating with each other, but allow all ports to communicate with a single
uplink port. This section is used to configure how each port will communicate with other ports
within the same private VLAN.
Web Interface
To configure the Port Isolation settings via the Web Interface:
1. Click Configuration, VLAN, Private VLAN’s and Port Isolation.
2. Tick the box next to the corresponding port to enable port isolation.
3. Click the Apply button to save your changes or the Reset button to revert to previous
settings.
Parameter Description
Port Members: A check box is provided for each port of a private VLAN. When checked, port
isolation is enabled on that port. When unchecked, port isolation is disabled
on that port. By default, port isolation is disabled on all ports.
Reset Button: Used to reset unsaved changes to original configuration.
Apply Button: Used to save the settings configured on this page.
Fig. 80 Port Isolation