User manual

APS User Manual
160
1.2.9-3 Power Delay
This section is used to configure time periods in which particular ports will power on the connected
PoE devices.
Web Interface
To configure the PoE Power Delay function via the Web Interface:
1. Click Configuration, PoE and Power Delay.
2. Enable or Disable the Power Delay function for each port and set the delay period in
seconds.
3. Click the Apply button to save your changes or the Reset button to revert to previous
settings.
Parameter Description
Port: Physical port of the switch.
Delay Mode: Enable or Disable the Power Delay function.
Delay Time: Set the delay time in seconds. When set, once the switch is powered on, the
switch will not supply power to this port until the delay period is reached.
Valid Values 0 – 300 seconds
Fig. 70 PoE Power Delay