User manual

APS User Manual
131
Parameter Description
MVR Mode: Used to enable or disable MVR globally on the switch.
VLAN ID: Specify the VLAN ID used for Multicasting.
Port: Physical port of the switch.
Mode: Enable MVR on a per port basis.
Type: Specify the port type, this can be either Receiver or Source. When set to
source, the port should be connected to a device that is sending the
multicast stream. If set to receiver, the port will be connected to a device
that is wanting to receive the multicast stream.
Immediate Leave: Enable Multicast’s fast leave parameter on the port.
Reset Button: Used to reset unsaved changes to original configuration.
Apply Button: Used to save the settings configured on this page.
Fig. 59 MVR Configuration