User manual

APS User Manual
12
1. Operation of the Web-based Management
This chapter instructs you on how to configure and manage the APS Series switches through the web
user interface. With this facility, you can easily access and monitor the switch through any of the
Ethernet ports and view the status of the switch, including MIBs status, each port activity, Spanning
tree status, port aggregation status, multicast traffic, VLAN and priority status, even illegal access
record and so on.
The default values of the APS Series switches are listed in the table below:
IP Address
192.168.1.1
Subnet Mask
255.255.255.0
Default Gateway
192.168.1.254
Username
admin
Password
To access the web management of an APS Series switch enter the default IP Address in web browser
and hit enter. E.g. http://192.168.1.1
Once you have entered the IP Address into the web browser you will be prompted to enter a
Username and Password in order to access the web management interface. Enter the default values
as shown in the table above.
The APS Series switches support a simple user management function allowing only one administrator
to configure the system at the same time. If there are two or more users using the administrator’s
identity, it will allow only the first user who logs in to configure the system. The rest of the users,
even with administrator’s identity, can only monitor the system. For those who do not have
administrator access they will only be able to monitor the system. Only a maximum of three users
are able to login simultaneously.
NOTE:
The APS Series switches support management interface on both
IPv4 and IPv6 IP Addresses.
To optimize the display, we recommend you use Microsoft IE 6.0
and above, Netscape V7.1 and above or FireFox V1.00 and above
and a screen resolution of 1024x768.