User manual

APS User Manual
118
Parameter Description
Snooping Enabled: Enable MLD Snooping on the switch.
Unregister IPMCv6
Flooding Enabled: Enable unregistered IPMCv6 flooding enabled.
MLD SSM Range: SSM (Source –Specific Multicast) range allows SSM-aware hosts and routers
that run the SSM service model to use groups in the configured address
range. Format: <IP Address v6>/<subnet Mask>
Proxy Enabled: Enable MLD Proxy. This feature can be used to avoid forwarding
unnecessary join and leave message to the MLD router.
Port: Physical port of the switch.
Router Port: Specify which ports are connected to a Layer 3 multicast device of MLD
Querier. If an aggregation member port is selected as a router port, the
whole aggregation group will act as a router port.
Fast Leave: Enable Fast Leave on the port. Fast Leave allows the switch to remove an
interface from the MLD table if there are no members listening on that
multicast group. Normally the group would not be removed until the
expiration timer has exceeded.
Fig. 53 MLD Snooping Configuration