User manual

APS User Manual
107
1.2.5-2 VLAN Configuration
This section is used to configure specific IGMP Settings for each of the configured VLAN groups.
IGMP Snooping can be enable or disabled for every individual VLAN group. 20 VLAN groups will be
displayed on the screen by default this can be increased to a maximum of 99. The VLAN with the
lowest VID will be displayed at the top of the table. To browse to additional pages use the arrow
keys at the top of the page.
Web Interface
To configure the IGMP VLAN Configuration parameters via the Web Interface:
1. Click Configuration, IGMP Snooping and VLAN Configuration.
2. Select the appropriate IGMP parameters for the specific VLAN group.
3. Repeat for all VLAN groups configured on the switch. Use the arrow keys to move between
pages. The Refresh button can be used to refresh the page for the latest information.
4. Click the Apply button to save your changes or the Reset button to revert to previous
settings.
Parameter Description
VLAN ID: The VLAN ID of each VLAN group.
Fig. 48 IGMP VLAN Configuration