User manual

NANO 2 – Managing & Handling Nano2PBX
User Manual v2.8
www.allo.com
61
10.8. Pickup Group
If a phone belongs in a Pickup Group that matches one of the call’s call groups that phone
may pickup the incoming call by calling *8# on his phone.
10.9. Pickup extension
If you want to pick up a particular Extension in the same Pickup Group, then dial *8 followed
by the Extension number.
10.10. Call Duration
It is the maximum timeout for which an outgoing FXO call is established. In Feature Settings
the Call Duration Timeout is given.
10.11. IP Trunking
IP Trunking is also know as Trunking Without Registration. With IP Trunking it is possible to
make Voip Trunk calls from Nano2 without Registration.
10.12. Hard Reset
A factoryreset button is provided in the back panel of Nano2PBX. This will hard reset the
Nano2PBX. Press and hold the red button for 5-6 seconds, so that the Nano2PBX will reset
to factory settings. Hard reset is for factory default, you will lose your configuration.
10.13. USB Drive
A USB flash drive is a data storage device that includes flash memory with an integrated
Universal Serial Bus (USB) interface.USB flash drives are typically removable and
rewritable. 8 GB USB drive available along with Nano2PBX v2 for storing MoH, Voicemail,
and Call Recording.
10.14. NPA Dialing
The North American Numbering Plan (NANP) is an integrated telephone numbering plan of
24 countries and territories: the United States and its territories, Canada, Bermuda, and 16
of the Caribbean countries.
For E.g.: If this is your phone number, 001-2127773456, then you can configure as NPA in
the Dial out Rules as a 001212+XXXXXXX where 001 is a Country code and the 212 as a
Area code and X is a number of digits to dial out. In this above case you have to dial only
7773456 from any of the Nano2PBX Extensions. Once you dial, it will compare the number
of digits which is configured in the Dial out Rules configured for NPA.