User manual

NANO 2 – Status
User Manual v2.8
www.allo.com
48
6. Additional Features
6.1. Conferencing:
The conference bridge configurations can be accessed under Advance Features
>Conference. In this page, users could create, edit and delete conference bridges.
Nano2PBX supports up to 8 simultaneous PSTN or IP participants irrespective of the
number of conference bridges.
Conference Bridge Settings
Extension
Configure the conference number for the users to dial into the
conference.
Play Hold Music For First
Caller
If enabled, the Nano2PBX will play Hold music to the first
participant in the conference until another user joins in. The
default setting is "No".
Announce Callers Count on
joining the Conference
If enabled, the caller will be announced to all conference
participants when there the caller joins the conference. The
default setting is "No".
Quiet Mode
If enabled, if there are users joining or leaving the conference,
voice prompt or notification tone won't be played. The default
setting is "No".
Working Scenario
By dialing the extension number configured in the above step will allow you to enter into
Conference Bridge. During the conference call, users can manage the conference from web
GUI.Log in Nano2PBX web GUI during the conference call, the participants in each
conference bridge will be listed in the “System Status” Page you can kick out the participant
by “ Click on to kick” a participant from the conference.
Important Note:
1.Nano2PBX will initiate the conference call only with G711u-Law codec with 20ms latency. Please
make sure you have enabled the same codec in all the conference IP phones
2. Audio Conference Bridge supports Max 8 users irrespective of the Number of Conference bridge.