User manual

NANO 2 – Additional Features
User Manual v2.8
www.allo.com
43
5.4.4. Reboot
Navigation: Admin Settings > Reboot: This is where you can configure the General
Settings of the Nano2PBX
The administrator of the Nano2PBX can remotely reboot the Nano2PBX by pressing the
“Reboot” button at the bottom of the System management. Once done, following screen will
be displayed to confirm reboot.
The user can re-login to the phone after POWER LED and all the six PHONE LED's turn
orange and remain stable on the Front Panel of your Nano2PBX
Important Note:
1) Nano2PBX will take about 3 minutes time to reboot and keep patience . ) Rebooting the Nano2PBX
results in termination of active calls.
2) IP address of the Nano2PBX after reboot, Please check the IP Address by dialing **# from the
Analog Phone connected to FXS port of the Nano2.
3) While rebooting the nano2 PBX ,the front panel LED’s will blink in blue/orange ,once PBX booted
the LED’s will be orange
5.5 SIP Settings
5.5.1. General
Navigation: SIP settings > General: This is where you can configure the General sip
settings.
General
Bind UDP Port
Configure the UDP port used for SIP. The default setting is 5060.
Bind IP Address
Configure the IP address to bind to. The default setting is 0.0.0.0,
which means binding to all addresses.
Enable DNS SRV
lookups
Select to enables DNS SRV lookups on outbound calls from the
Nano2PBX. The default setting is “No"