User manual

NANO 2 – Additional Features
User Manual v2.8
www.allo.com
41
VoIP Phone Digit Map: This option allows the administrator to define a global digit mapping
string compatible with RFC 3435. There is no default setting and this option does not sync
with the dial plan assigned to an individual user. The following examples should assist in
writing an acceptable digit mapping string.
• [2-9]11 - Where calls beginning with digits 2-9 followed by digits 11 are dialed
immediately.
• 0T - Where calls beginning with digit 0 followed by a pause equal to the "Digit
Timeout" option.
• +011xxx.T - Where calls beginning with the + character, followed by 011
digits and then at least three more digits before any arbitrary number is
matched, dialed after Digit Timeout is reached.
• 0[2-9]xxxxxxxxx - Where calls beginning with 0, followed by any digit from 2-
9, followed further by 9 more digits are dialed immediately.
• +1[2-9 xxxxxxxx - Where calls beginning with the + character, followed by 1,
followed by any digit from 2-9, followed by 8 more digits are dialed
immediately.
• [2-9]xxxxxxxxx - Where calls beginning with any digit from 2-9, followed by 9
more digits are dialed immediately.
• [2-9]xxxT - Where calls beginning with any digit from 2-9, followed by three
more digits are dialed after Digit Timeout is reached.
• [2-9]11|0T|+011xxx.T|0[2-9]xxxxxxxxx|+1[2-9]xxxxxxxx|[2-9]xxxxxxxxx|[2-
9]xxxT where each entry is separated by the | character. For more
information, please refer to RFC 3435.
VoIP Phone Digit Timeout: The timeout variable is the number of seconds the phone will
wait for each segment of a digit map expressed as an integer.
5.4.2. Language
Navigation: Admin Settings > Language: This is where you can configure the Language
Settings of the Nano2PBX.
Language settings allow the user to specify the default language voice prompt. The currently
available voice prompts are English, Spanish, Turkey, French and Italy.
By default selected voice prompt language is English.
5.4.3. PBX Settings
Navigation: Admin Settings > PBX Settings: This is where you can configure the General
Settings of the Nano2PBX
Change Admin Password:
• Enter the new password and retype the new password to confirm. The new
password field has to be at least 5 characters
• Click on “Update” and the user will be logged out.