User manual

NANO 2 – Additional Features
User Manual v2.8
www.allo.com
39
Disconnect
Default code: *2
This is to assign the code for performing call disconnect
Attended Transfer
Default code: *3
Enter the code during active call. After hearing "Transfer", you
will hear the dial tone. Enter the number to transfer to and the
user will be connected to this number. Hang up the call to
complete the attended transfer.
Call Parking
Default code: *4
Enter the code during active call to park the call.
Call Pickup
Default code: *8
This feature code is to pick up the ringing extension from
another extension if the party is not available in the desk.
Call Record
Default code: *9
This is to assign the code for performing Call Record. If the
Nano2PBX user extension wants to record the particular active
call, then he needs to press Call record feature code and that
call conversation get recorded.
Call Back
Default code: *7
E.g.: If you want to make call back between your phone and
remote party 2002, dial *72002 from your phone then it will
hang-up automatically. The remote party side he will get the
call and once he answers the call, you will get the call back.
Suppose If remote party didn’t answer the call, it will retry the
call with retry count.
Normal Time Mode
Default code: *45
To deactivate Day/Night manual switching.
Day Time Mode
Default code: *46. To enable the Day mode for a specific Time
interval.
Night Time Mode
Default code: *47. To enable Night Mode for a specific Time
Interval.