User manual

NANO 2 – Additional Features
User Manual v2.8
www.allo.com
37
5.2. Network Settings
Navigation: Network Settings: This is where you setup your Networking Configuration
5.2.1. WAN Configuration
Please refer to the following tables for basic network configuration parameters
WAN Configurations
IP Address Mode Select DHCP, Static IP. The default setting is DHCP.
IP Address Enter the IP address for static IP settings.
Subnet mask Enter the subnet mask address for static IP settings. The default
setting is 255.255.255.0
Network Id your local network segment (Ex: 192.168.0.0)
Broadcast Enter the broadcast address
Gateway Enter the gateway IP address for static IP settings.
DNS Primary Enter the DNS server 1 address for static IP settings
DNS Secondary Enter the DNS server 2 address for static IP settings
Important Note:
DHCP mode isn't recommended. Or trouble may arise when SIP client need to change registration
server address caused by revised IP.
5.2.2. LAN Configuration
Use this setting in the event that you want to use the Nano2PBX as your network router and
act as a DHCP server.
By default LAN IP address is 192.168.113.1 & you cannot change the ipaddress of LAN
interface.
Important Note:
WAN port IP and LAN port IP Address shouldn't be in the same net segment. And we recommend not
to change LAN address.