User manual

NANO 2 – Setting up Features
User Manual v2.8
www.allo.com
17
Host Name Configure the IP address or URL for the VoIP provider’s
server of the trunk.
Host Port Enter the port number given by the VOIP provider. 5060 is
the default SIP port. If configuring any roaming extension or
if connecting nano2 to public network then consider
changing the SIP port for better security. Once port changes
are done , for registering IP phones/sip phone use <domain
name ><sip port number>.
Username Enter the username to register to the trunk from the
provider.
Password Enter the password to register to the trunk from the provider.
Qualify If you enable Qualify, asterisk will send the SIP Options
command regularly to check that the device is still online
Fax Detect Configure a Fax destination where incoming Fax will be
detected and received.
DID Routing DID Routing Routes calls to a single ,specific extension.
TrunkingWithout
Registration
Trunking Without Registration is to make voip trunk calls
from Nano2 Without Registration.
Outbound Proxy Configure Outbound proxy to send Outbound signaling to
that proxy.
4.3.4. Editing / Deleting an Existing VoIP Account:
On the right side of the page, you can see the list of VoIP trunk you have setup. To edit, or
delete any of them, simply click the appropriate icon provided to the right of each trunk.Once
you click on the edit button of a VoIP trunk then it will display the information of that
particular VoIP trunk, here you can change the required details and click on the Save button
and then click on the apply changes tab to save the changes made.
To ensure successful registration of your VoIP Trunk, you must click the “System Status” tab
on the top navigation menu (see Status section for more info)
Important Note:
Make sure to click the APPLY CHANGES tab in the top navigation bar, after adding any new VoIP
trunk, or editing / deleting.4.4 Outgoing Calling Rule