User manual

MegaPBX – Getting Started
9
User manual V2.0 www.allo.com
Notification LEDs (On the Front Panel):
2.2 Access the web GUI:
MegaPBX Web GUI can be accessed either through WAN or LAN interface. Steps to
Access the GUI during the initial setup through LAN interface:
Step 1: Make the setup as mentioned previously in the hardware setup
Step 3: Make sure the Network setting of the PC is set in automatic mode (i.e. DHCP mode). An
IP address will be accessed to the PC in the 192.168.113.xxx series (By default DHCP server
releases IP address on the LAN interface).
Step 4: Launch the web browser and enter the URL http://192.168.113.2 to open the login page
of MegaPBX Graphical Interface.
Step 5: Login using the default username & password (Default: Username: admin; Password:
admin). Successful login takes you to the Dashboard page (figure 2-1). Observe the WAN IP
address on the dashboard, this will be used to access the GUI from the WAN interface.
After successful login we get a MegaPBX Home Dash Board. To guarantee the system safety,
When login for the first time, we need to modify Password. For modifying the password go to