User manual

MegaPBX – Getting Started

User manual V2.0 www.allo.com

2. Getting Started With the MegaPBX

2.1 Hardware Setup

1. Plug one end of the RJ45 Ethernet cable into your Network Switch

2. Plug the other end of the RJ45 Ethernet cable into the WAN port of the

MegaPBX

3. Connect a PC to the LAN port of the MegaPBX, Enable the DHCP option in the

Network Settings of the PC

3. Plug the Power Adapter included into an available power outlet

4. Plug the other end of the Power Adapter into the “DC-IN” port of the MegaPBX

5. The MegaPBX will power up (Boot up time takes about 160 secs)

Important Note:

Use straight – through Ethernet cable to connect between the MegaPBX to Router/Switch/PC