User manual

44
User manual V2.0 www.allo.com
4.8 CDR Settings:
The call records can be exported to Radius server or FTP server.
Radius Server Configuration: This will allow you to configure the radius server information
where all the records will be saved.
Enable Radius Server: EnableRadius field to for Enable RADIUS access control
EnableRadius = Enabled, Radius Accounting of Call Detail Record should be enable and allows
administrator to configure the configuration parameters
Server IP Address: IP address of the Radius Sever
Server port: Port number of the Accounting Radius server
Password: Shared password between radius Client and server
Radius VSA Attrib: To specify the Radius Vendor specfic attribute ID.
Applicable values: CISCO, DIGIUM
Default value: CISCO
Radius Retry Count:
Value: Integer value ( 1 to 10)
Default value: 2 sec
Radius Retransmission Interval:
Value Integer Value( 1to 10)
Default: 3
Radius Retransmission and radius retransmission interval is used if there is no response from
the Radius server