User manual

MegaPBX- Setting up features
15
User manual V2.0 www.allo.com
Authentication: Used for SIP trunk authentication. If Authentication is required, check
Authentication box and enter Authentication user name and Password provided by the VoIP
service provider.
Registration Mode: Enable if registration required from the VoIP Service provider
Registrar Address: Domain name/ IP Address of registrar. If the registrar address is not
provided by the Service provider use the proxy address itself
Bridge PIN: This password is required to bridge the VoIP calls between two trunks. If not
required, leave it blank.
SIP Trunk Group: Select the appropriate SIP Trunk Group.
Inbound Call Handling: This feature allows you to route the incoming calls to particular
extension/ IVR/Queue/Voicemail Group.
3.2.13 Dial out Rules:
Patterns: We should take care to create valid dial plans so as to ensure that our calls are
handled via the appropriate trunks. Many people get confused about dial plan pattern
construction; but it doesn't have to be that difficult. The following table lists the special dial plan
pattern characters and their significance:
Special Dial plan Pattern Characters Significance
X Matches any digit from 0-9
Z Matches any digit from 1-9
N Matches any digit from 2-9
[1237-9] matches any digit or letter in the brackets (in this
Example 1,2,3,7,8,9
. Wildcard; matches one or more characters
| Separates dialing prefix from number
For e.g. adding '01|X.' in the Dial Pattern and selected a “VoIP Provider1” in Trunk Sequence,
will allow user to dial 014567807890 numbers, so that 01 will be stripped off from the dialed