User manual

MegaPBX- Setting up features
14
User manual V2.0 www.allo.com
3.2.6 SIP Trunk Groups:
Group Name: Enter a descriptive name in this field to identify the configured SIP trunk Group.
By default: DefSIPtrunk
DTMF Mode: You can enable/Disable the Email alerts on arrival of new voicemail & MWI
Features: You can enable/Disable NAT, FAX and DID Routing
NAT: It should be check if the device is behind a NAT router. Enable this option to
avoid NAT Traversal issues.
Fax: If it is checked then T.38 supported, if unchecked only FAX pass through is
supported.
DID Routing: This field is used to route incoming calls when a DID (Direct Inward
Dialing #) is used instead of the account ID. It is very helpful when there are several DIDs
related to the same (static) trunk provided by your SIP Trunk Service Provider.
Codec Configuration: This field allows you to enable a Codec's according to your preference.
Click on “SAVE “button.
You can create new SIP Group Configuration by clicking “CREATE”
3.2.7 SIP Trunks:
This is where you can configure VoIP Service provider Accounts
The details of the Configuration page are as follows:
Account Name: SIP service subscriber name which will be used for Caller ID display.
User Name: User account information, provided by VoIP service provider (ITSP), usually has
the form of digit similar to phone number or actually a phone number.
Proxy Address: IP address or Domain name provided by VoIP service provider. By default port
number will be 5060
Out Bound Proxy Address: A proxy that receives requests from a client, even though it may
not be the Server resolved by the Request-URI. Out bound proxy IP Address provided by the
VoIP service provider.