Specifications

into an available power outlet
Step 4: Plug the other end of the Power
Adapter into the “DC-IN” port of the
NanoPBX
Step 5: The NanoPBX will power up, and automatically connect itself to your network via DHCP (which
you can later configure in the SETTINGS > Network Settings section)
Important Note:
• Wait until the POWER and all the six PHONE LED's turn orange and remain stable on the Front Panel
of your NanoPBX.
• Use Straight – through Ethernet cable to connect between the NanoPBX to Router/Switch/PC
Step 6: Configure your NanoPBX according to the instructions below
2.2 Accessing the GUI (Graphical User Interface)
Connect an Analog phone to the any of the FXS ports of the NanoPBX and dial “* *” to get the WAN IP
address of the NanoPBX. And then launch the web browser on the PC which is connected to the same
network to get GUI Login Screen.
Or also you can access the GUI of the NanoPBX by connecting a PC to the LAN port of the NanoPBX.
Enable the DHCP option in the Network Settings of the PC, and then enter http://192.168.113.1 in the
Web Browser Address field. (Where 192.168.113.1 is the default local IP address of the NanoPBX).
On the login screen, the default username and password is “admin/admin”. Press the Login button to
enter the NanoPBX web panel. To change the password, please refer to the SETTINGS > General section
in the navigation.
After you login, you are brought to an Overview screen, which offers information about the NanoPBX,
and help files to assist you in learning about the different features of the system.