Specifications
8.5 Call Parking
Enables a user to hold a call and to retrieve it from another station within the group. To park a call, dial
the Blind Transfer prefix code followed by Call Parking feature code i.e. *8 7000. The call is parked and
the caller is held. And it will announce the parked extension (i.e. 7005).
To retrieve the call, the user can go to any phone in the group and dial the parked extension (i.e. 7005).
Then call will be retrieved and connects to the retrieved user.
Use the following steps to park and retrieve the call:
1. While you are on a call, press the transfer button on your phone
2. Dial extension 7000 (default)
3 . P B X a n n o u n c e s t h e p a r k e d e x t e n s i o n ( e . g . 7 0 0 1 , 7 0 0 2 , e t c . )
4 . H a n g - u p t h e p h o n e
5. To r e t r i e v e the parked call, dial the previously announced parked extension (7001,
7002, etc.)
8.6 Call Hold and Retrieve
Enables users to automatically hold and retrieve incoming calls without requiring the use of feature
access codes. This feature is especially useful for attendants managing a large volume of incoming calls.
Any user can put a call on hold by pressing the Flash key. The extension on hold will start getting Music
on hold. The same call can be retrieved back by pressing the flash key again.
8.7 BLF (Busy Lamp Field) Support
NanoPBX supports BLF, which sends information about other extensions to a phone connected to the
same PBX to inform the status.
By default BLF Support is enabled. This feature is used by a receptionist or secretary for routing incoming
calls.
8.8 Hard Reset
A reset button is provided in the back panel of NanoPBX. This will hard reset the NanoPBX. Press and
hold the red button for 2-3 seconds, so that the NanoPBX will reset to factory settings.
8.9 Memory Card Handling
When handling a memory card, do so without touching the contacts on its edge. Make sure the card faces
the correct direction if you are inserting it into NanoPBX memory card slot. Never force it into the slot. If
it fails to insert into the slot fairly effortlessly, make sure it’s facing the right direction. Power-off
NanoPBX before inserting or removing memory card.