Specifications

4.11 Port Configuration
Port Configuration allows you to manually configure Ports 5 and 6 either as FXS ports or FXO ports, which
are configurable ports on the NanoPBX. That means you can configure these ports to be either as FXS
ports (to connect Analog Phones) or FXO ports (to connect PSTN line).
Important Note:
a) After choosing the port configuration click on Update Port Config Button, NanoPBX
will reboot for the changes to take effect. Once the system comes up you can use the ports as per your
configuration.
b) Please make sure to disconnect incoming PSTN Line connected to the Port Number
5 and 6 before you switch from 4FXS and 4FXO Mode to 6FXS and 2FXO Mode. It may damage your
NanoPBX Unit.
5. Status
5.1 Status
Navigation: STATUS: Status: This is where you can check the overall status of your NanoPBX, including
Memory Status, VoIP Status, Networking Status and Client Status (to see which clients are connected to the
system).