Specifications

based on the line which you are connecting to the FXO port of NanoPBX. The default is 600.
4.9.3 Stacking NanoPBX
This feature will allow user to connect two NanoPBX together and make double the capacity of NanoPBX.
User of one NanoPBX can reach the users of another NanoPBX directly by dialing there extension number
and also user can access the trunk of other NanoPBX directly by dialing prefix configured in other
NanoPBX.
Both the NanoPBX should be connected to same network and following details should be provided in both
the NanoPBX.
Enable Stacking - The feature can be enabled by checking the Enable Stacking checkbox.
Peers PBX - Peer PBX is the other NanoPBX to which you are bridging.
IP Address - IP Address is the other NanoPBX to which you are bridging.
I m porta n t N ot e :
Both NanoPBX should not have the same extensions number or prefix for accessing trunks. In this case
call will get establish to the user or trunk of same PBX.
4.9.4 Block / Allow
This feature is to allow / block the calls based on the caller id for PSTN lines. Please make sure the
caller-id is detected in your PSTN line to work with this feature.
4.10 Manage System
The administrator of the NanoPBX can remotely reboot the NanoPBX by pressing the “Reboot” button at
the bottom of the System management. Once done, following screen will be displayed to confirm reboot.
The user can re-login to the phone after POWER and all the six PHONE LED's turn orange and remain
stable on the Front Panel of your NanoPBX
Telnet option is by enabled by default. Uncheck this option to disable telnet access for the NanoPBX if
required. This will be used for troubleshooting purpose.