Specifications

3. Password: Set a password to register to (SIP) servers provided by the ITSP.
4. Authorization UserID: Same as username.
5. Proxy IP Address: IP address or Domain name provided by VoIP service provider.
6. Proxy Port (Default: 5060): Used to set the Proxy Port numbers. By default port number will be 5060.
7. Domain/Realm: Domain name provided by VoIP service provider.
8. Registration Time-out: This option enables SIP sessions to be periodically "refreshed" via a re-invite
request. Once the session interval expires, if there is no refresh via a re-
invite message, the session will be terminated.
9. DTMF Mode: This parameter sets the payload type for DTMF using RFC2833
10. NAT: It should be check if the device is behind a NAT router.
11. Qualify: This feature is used to keep a UDP session open to a device that is located behind a
Network Address Translation (NAT).
12. Dial Settings:
Dial out Prefix – A numeric identifier value to cease the line. While creating the prefix please make
sure, it should not override the prefix in Setting > General Settings and PSTN
Settings
Bridge Password - This password is required to bridge the VoIP calls to PSTN.
Inbound Destination - This feature allows you to route the incoming calls to particular extension.
13. Codec Settings: This field allows you to enable a Codec's.
4.3.2 Editing / Deleting an Existing VoIP Account:
On the right side of the page, you can see the list of VoIP accounts you have setup. To edit, or delete any
of them, simply click the appropriate icon provided to the right of each account.
Once you click on the edit button of a VoIP account then it will display the information of that particular
VoIP account, here you can change the required details and click on the update VoIP account button and
then click on the apply changes tab to save the changes made.
To ensure successful registration of your VoIP Account(s), you must click the “STATUS” tab on the top
navigation menu (see Status section for more info)
I m porta n t N ote:
Make sure to click the APPLY CHANGES tab in the top navigation bar, after adding any new VoIP account,
or editing / deleting.