User manual

CRA-210 User Manual Guide
_______________________________________________________________________________
Page: 28 of 30
4.3. Telephony Features
4.3.1. Call Hold
While A and B are in conversation, pressing the “FLASH” button on the attached phone
will put the remote end on hold. Pressing the “FLASH” button again will release the
previously Hold party and the bi-directional media will resume.
4.3.2. Call Waiting
Call waiting feature is enabled by default. While the user is in a conversation, he will
hear a special stutter tone if there is another incoming call. User can press the flash button
to put the current call party on hold and switch to the other call. Pressing flash button
toggles between two active calls.
4.3.3. Call Transfer
4.3.3.1. Attended Call Transfer
Assuming that call party A and B are in conversation. A wants to Transfer to C:
1. A party press “ *7 ” on the analog phone to transfer a call. Then A party will get a
dial tone to make call to another party, to which call to be transferred.
2. A party dials C’s party number (or wait for 4 seconds)
3. If C answers the call, A and C are in conversation. Then A can hang up to complete
attended transfer.
4.3.3.2.
Unattended Call Transfer
Assuming that call party A and B are in conversation. A wants to Transfer to C:
1. A party press “ *5 ” on the analog phone to transfer a call. Then A party will get a
dial tone to make call to another party, to which call to be transferred.
2. A party dials C’s party number (or wait for 4 seconds)
3. Once C answers the call, B and C are in conversation by hanging-up A party call.