User manual

CRA-210 User Manual Guide

_______________________________________________________________________________

Page: 11 of 30

Figure 4.3

Wait until the POWER,

and WAN LED's turn

green and remain stable

on the Front Panel of

your ATA (LAN LED

might also be green).

4.2. Configuring CRA-210 through Web Browser

Your ATA Web Panel will allow you to configure and modify the Network Settings,

SIP settings and to upgrade your ATA's Firmware. And it will also allow you to

check the status of SIP your account

4.2.1. To access your ATA Web Panel, follow these simple guidelines:

STEP 1: First, connect the ATA’s LAN port to your PC network card and then

disable & enable the Local Area Connection available in the Control

Panel -> Network Connections. The ATA will release the IP address in

the series of 192.168.113.X. And then launch the web browser on

the PC. Enter http://192.168.113.1 in the Address field

(192.168.113.1 is the default local IP address of the ATA). Then press

the Enter key.

STEP 2: Or you can login to the ATA through the WAN IP address if both

ATA and PC are connected to the same network (which is connected to

the DHCP server), then you can get the IP address of the ATA through

the phone connected to ATA by dialing “ * * ”. Then it will announce

the current WAN IP Address, which is released by the DHCP server.

Then enter WAN IP address in the web browser address field to get

the following URL:

http:// CRA-210 -IP-Address

where the CRA-210-IP-Address is the IP address of the CRA-210.