User manual

CRA-210 User Manual Guide
_______________________________________________________________________________
Page: 10 of 30
3.2. Other Requirements:
• Telephone Unit
• Broadband Internet connection (DSL or Cable Modem)
• A Router (if you have multiple devices using Internet connections)
• An ITSP VoIP Account
4. CONFIGURATION GUIDE
4.1. Hardware Installation
To install the Analog Telephone Adapter (ATA) follow these instructions.
4.1.1. Connect the Ethernet network cable (RJ45) into the WAN port of the ATA
unit, as shown in Figure 4.1: Connect the other end to the one of the
Ethernet ports on your router or gateway.
Figure 4.1
4.1.2. Connect the Standard Telephone Cable (RJ11) into the phone port labeled
PHONE as shown in Figure 4.2. Connect the other end of the cable to your
telephone. You can plug either phone or fax machine.
Figure 4.2
4.1.3.
Connect the included power adapter to the POWER port on the back panel
of the Phone Adapter as shown in Figure 4.3. Connect the other end to a
standard electrical outlet, which will power up the ATA unit.