User`s guide
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Basic Setup
- Chapter 3 Viewing Live Video
- Chapter 4 Advanced Viewing Setup
- Chapter 5 Web-based Management
- Introduction
- Connecting to Network Camera
- Welcome Screen
- Administration Menu
- System Screen
- Network Screen
- Wireless Screen (ALL2250 and ALL2211 only)
- DDNS Screen
- Video Image Screen
- Video Access Screen
- User Database Screen
- Pan/Tilt Screen (ALL2250 only)
- Motion Detection Screen
- E-Mail Alerts Screen
- Maintenance Screen
- Status Screen
- Log Screen
- Chapter 6 Windows Viewing/Recording Utility
- Chapter 7 Troubleshooting
- Appendix A Specifications
- Appendix B Streaming Video/Audio Solution
Making Video available from the Internet
If your LAN is connected to the Internet, typically by a Broadband Gateway/Router and
Broadband modem, you can make the Network Camera available via the Internet. You will
need to configure your Router or Gateway to allow connections from the Internet to the
camera.
Router/Gateway Setup
Your Router or Gateway must be configured to pass incoming TCP (HTTP) connections (from
Internet Viewers) to the Network Camera. The Router/Gateway uses the Port Number to
determine which incoming connections are intended for the Network Camera.
This feature is normally called Port Forwarding or Virtual Servers, and is illustrated below.
The Port Forwarding/Virtual Server entry tells the Router/Gateway that incoming TCP
connections on port 1024 should be passed to the Network Camera. If necessary, check the
user manual for your Router/Gateway for further details.
Figure 21: Connecting via the Internet
The "Port" for the Port Forwarding / Virtual Server entry
above is the " Secondary Port" number specified on the
Network screen of the Network Camera.
24