User`s guide
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Basic Setup
- Chapter 3 Viewing Live Video
- Chapter 4 Advanced Viewing Setup
- Chapter 5 Web-based Management
- Introduction
- Connecting to Network Camera
- Welcome Screen
- Administration Menu
- System Screen
- Network Screen
- Wireless Screen (ALL2250 and ALL2211 only)
- DDNS Screen
- Video Image Screen
- Video Access Screen
- User Database Screen
- Pan/Tilt Screen (ALL2250 only)
- Motion Detection Screen
- E-Mail Alerts Screen
- Maintenance Screen
- Status Screen
- Log Screen
- Chapter 6 Windows Viewing/Recording Utility
- Chapter 7 Troubleshooting
- Appendix A Specifications
- Appendix B Streaming Video/Audio Solution
Setup using the Windows Wizard
Initial setup should be performed using the supplied Windows-based setup Wizard. This
program can locate the Network Camera even if its IP address is invalid for your network. You
can then configure the Network Camera with appropriate TCP/IP settings for your LAN.
Subsequent administration can be performed with your Web browser, as explained in Chapter
5 - Web-based Management.
Setup Procedure
1. Insert the supplied CD-ROM into your drive. If the setup program does not start
automatically, run Setup.exe in the root folder.
• You will see the Welcome screen shown below.
• Click the Setup Camera button to start the setup Wizard
Figure 2: Welcome Screen
2. The next screen, shown below, will list all the Network Cameras on your LAN.
Figure 3: Camera List Screen
8