User`s guide
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Basic Setup
- Chapter 3 Viewing Live Video
- Chapter 4 Advanced Viewing Setup
- Chapter 5 Web-based Management
- Introduction
- Connecting to Network Camera
- Welcome Screen
- Administration Menu
- System Screen
- Network Screen
- Wireless Screen (ALL2250 and ALL2211 only)
- DDNS Screen
- Video Image Screen
- Video Access Screen
- User Database Screen
- Pan/Tilt Screen (ALL2250 only)
- Motion Detection Screen
- E-Mail Alerts Screen
- Maintenance Screen
- Status Screen
- Log Screen
- Chapter 6 Windows Viewing/Recording Utility
- Chapter 7 Troubleshooting
- Appendix A Specifications
- Appendix B Streaming Video/Audio Solution
• The Network LED should be ON.
For more information, refer to Physical Details - Network Camera in Chapter 1.
Using PoE (Power over Ethernet)
The ALL2201 Network Camera supports PoE (Power over Ethernet). To use PoE:
1. Do not connect the supplied power adapter to the Network Camera.
2. Connect one end of a standard (category 5) LAN cable to the Ethernet port on the Network
Camera.
3. Connect the other end of the LAN cable to the powered Ethernet port on a suitable PoE
Adapter. (12V DC, 1A)
4. Connect the unpowered Ethernet port on the PoE adapter to your Hub or switch.
5. Connect the power supply to the PoE adapter and power up.
6. Check the LEDs on the Network Camera to see it is drawing power via the Ethernet
connection.
7