User`s manual

Wireless N Extender Version 1.0

Firmware

Firmware menu allows you to see the current firmware version and build date as well as upgrade

the firmware of the device.

 Firmware Information – Shows the current firmware’s version and build date

 Firmware Upgrade – Load a new firmware upgrade file to the device

NOTE: Make sure you connect to the device via Ethernet cable when upgrading the firmware to

avoid corruption during the firmware upgrade procedure.

Setting a Static IP on your PC

The ALL0236R Wireless N Repeater will only give an IP address to your PC upon initial

installation. Once you have associated it with your Wireless Router/AP, you will no longer have

access to the device’s web GUI. If you wish to change any settings on the ALL0236R, you need

to set a Static IP address on your PC. Just remember to set it back to “Obtain and IP address

automatically” after you are done.

Set a static IP address on your PC using Windows XP

1. Click Start > Control Panel

2. Click on Network and Internet Connections