Specifications

Camera interfaces

Pearleye Technical Manual V2.0.0

The current (1) which flows through the optocoupler and the integrated drop-

ping resistor should be > 5 mA and should not exceed 20 mA.

Pearleye P-007 LWIR For continuous periodical trigger the pulse must be at least 100μs in length and

the periodic time exact 24.96ms ±10μs.

Pearleye P-030 LWIR For continuous periodical trigger the pulse must be at least 82μs in length and

the periodic time exact 41.608ms ±20μs.

Sensor temperature too low (Pin 12, 13)

As long as the sensor operating temperature is too low, the sensor control out-

put at pin 12/13 remains active (transistor switched on). Following the warm up

phase of the camera this output becomes inactive.

Figure 5: Trigger input diagram

Figure 6: Sensor temperature too low

Caution



Pearleye P-007 LWIR / Pearleye P-030 LWIR: The current

which flows through the optocoupler should not exceed 20 mA

(at 12 V R

 600 ).