Specifications

C613-10506-01-REV A Software Release Note AlliedWare Plus Version 5.4.2-0.1 13
platform silicon-profile New – – Y Y Switching
Commands
This command replaces the deprecated
command platform enhanced-mode. A
new silicon profile option for a
SwitchBlade x908 with all XEM-2XP,
XEM-2XT, and XEM-2XS XEMs
installed increases hardware table sizes.
show debugging loopprot
show debugging platform
packet
show flowcontrol interface
show loop-protection
show mirror
show storm-control
Modified Y Y Y Y Switching
Commands
These commands are now available
from the User Exec command mode
prompt (awplus>) and the Privileged
Exec command mode prompt
(awplus#).
show mirror interface Modified Y Y Y Y Switching
Commands
This command is now available from
the User Exec command mode prompt
(awplus>), the Privileged Exec
command mode prompt (awplus#)
and the Interface Configuration
command mode prompt
(awplus(config-if)#).
show provisioning (xem-
bay)
Modified – – Y Y Switching
Commands
This command is now available from
the User Exec command mode prompt
(awplus>) and the Privileged Exec
command mode prompt (awplus#).
show vlan classifier group
interface
New Y Y Y Y VLAN
Commands
Use this command to display
information about all switch port
interfaces or a single switch port
interface for all configured VLAN
classifier groups.
show vlan
show vlan classifier group
show vlan classifier interface
group
show vlan classifier rule
show vlan private-vlan
Modified YYYYVLAN
Commands
These commands are now available
from the User Exec command mode
prompt (awplus>) and the Privileged
Exec command mode prompt
(awplus#).
show vlan statistics Modified Y Y – – VLAN
Commands
This command is now available from
the User Exec command mode prompt
(awplus>) and the Privileged Exec
command mode prompt (awplus#).
vlan classifier activate Modified Y Y Y Y VLAN
Commands
This command can now optionally
associate a VLAN identifier with a
VLAN classifier group. This command
primarily associates and removes
VLAN classifier groups with switch
port interfaces in Interface
Configuration.
clear spanning-tree statistics Modified Y Y Y Y Spanning Tree
Commands
You can now optionally specify an MSTI
(Multiple Spanning Tree Instance)
instance to clear MSTP BPDU statistics
with this revised command.
Table 4: New and modified commands in 5.4.2-0.1
Command Status
x600 x610 x900
SBx908
Software
Reference
Chapter
Description