Specifications

GX1660 Technical Manual Page 17
Network Card Configuration
Operating GigE Vision GX cameras using multiple network adaptors
The GX series cameras offer two Gigabit Ethernet ports for image data transfer and control. Users can
connect one or both ports on the GX to Ethernet adapter ports on a host computer. Connecting both
ports will increase the available bandwidth to 240 MB/sec, allowing higher frame rates and resolutions
than a single port connection.
GX cameras can be operated in single port and dual port configurations. The dual port approach
requires the host computer to configure a Link Aggregate Group (LAG). A LAG configuration combines
multiple Ethernet ports into a single data channel.
1. Install a dual port network card in the host computer. To achieve full camera performance, you
should use a Gigabit Ethernet card that supports "Jumbo frames" of at least 9KB size.
2. Once installed, open your Network Connections (Start -> Control Panel->Network
Connections) and right-click on one of the two network connection corresponding to the card
that was just installed.
3. Select Properties from the contextual menu that
appears when you right click the network connection
icon. This will open the properties window.
4. In the properties window, click the Configure button. Select the Advanced tab. In the
Property list make the following changes:
(a) select Jumbo Frames and change the value to 9014 bytes or higher.
(b) select Receive Descriptors on the same list and change the value to 512
(c) select "Performance Options" and set "Interrupt Moderate Rate" to "Extreme"